@Blitzplotter: The first three parameters of FitMesh() are positions not dimensions. You don't need to use it anyway though, use ScaleMesh() only instead. If the width equals zero then yes it will cause a problem. You will need to return floats with MeshWidth() etc, not integers. If the width is less than 1.0 then it will return an integer of zero. Return floats instead like this...
@Sph!nx: No, each update is free. I send out emails to all users with the new download link to the email address they registered when purchasing JV-ODE.
If you haven't received the update email and are still using the registered email address, double check it hasn't been filtered as spam.
If your registered email address is no longer used and gives errors when sending emails, it will be removed from the updates list after two failures in succession.
If you need to update your registered email address or are still unable to find the update email, send me an email with details of your original purchase and I will update it and send a new download link for you.
deep#=MeshDepth(ode\mesh) tall#=MeshHeight(ode\mesh) width#=MeshWidth(ode\mesh) ScaleMesh ode\mesh,width*0.5,tall*0.5,deep*0.5
@Sph!nx: No, each update is free. I send out emails to all users with the new download link to the email address they registered when purchasing JV-ODE.
If you haven't received the update email and are still using the registered email address, double check it hasn't been filtered as spam.
If your registered email address is no longer used and gives errors when sending emails, it will be removed from the updates list after two failures in succession.
If you need to update your registered email address or are still unable to find the update email, send me an email with details of your original purchase and I will update it and send a new download link for you.