I havent been on line in a while..
@MGE I have seen a couple of comments regarding stablity of the Dx9 Max2d module that I wrote.
If you would care to share or provide an example of your problem, I would be more than willing to look at it. The only known issue that arose are it does not work correctly on older Intel Chipsets. Although all my requests for people with that chipset have never been responded too to attempt to find resolution.
There was also a bug in the early 1.26/28 (cant remember) with issues with reflection that required a fix to the compiler. That has been corrected. Also issues caused by bugs in the BMAX debugger could cause problems single stepping if you wound up in the Dx9 codde. This too to my knowledge has been corrected. These two issues where not driver problem but BMAX problems.
Now if you would provide a working example that demonstrates this "instablility" and possibliy some feedback on what hardware you are experiencing the problem I might be able to address the issues.
Regards
Doug Stastny
@MGE I have seen a couple of comments regarding stablity of the Dx9 Max2d module that I wrote.
If you would care to share or provide an example of your problem, I would be more than willing to look at it. The only known issue that arose are it does not work correctly on older Intel Chipsets. Although all my requests for people with that chipset have never been responded too to attempt to find resolution.
There was also a bug in the early 1.26/28 (cant remember) with issues with reflection that required a fix to the compiler. That has been corrected. Also issues caused by bugs in the BMAX debugger could cause problems single stepping if you wound up in the Dx9 codde. This too to my knowledge has been corrected. These two issues where not driver problem but BMAX problems.
Now if you would provide a working example that demonstrates this "instablility" and possibliy some feedback on what hardware you are experiencing the problem I might be able to address the issues.
Regards
Doug Stastny