This is not a bug, but an annoyance in the documentation. When I go to the command reference (see menu below) I am already thinking about the command I want to look up (usually). I know whether it is a 3D command or not - the human brain is very good after all at visualizing 3D things.
But the first choice I have to make is whether I want the commands by category or A-Z. Once I decide that I have to remember the command I was looking up. For some reason this scrambles my brain and I click the wrong link more often than not.
If I'm the only one, fine, but I bet everyone has this problem.
Below is the current version followed by my suggested improvement:
Improved version(imo):
As I say, feel free to ignore this if I'm the only one. :-)
But the first choice I have to make is whether I want the commands by category or A-Z. Once I decide that I have to remember the command I was looking up. For some reason this scrambles my brain and I click the wrong link more often than not.
If I'm the only one, fine, but I bet everyone has this problem.
Below is the current version followed by my suggested improvement:
Command Ref. 2D - Category 3D - Category 2D - A-Z 3D - A-Z ASCII Codes Scancodes Scancodes Picker Index
Improved version(imo):
Command Ref. 2D - Category 2D - A-Z 3D - Category 3D - A-Z ASCII Codes Scancodes Scancodes Picker Index
As I say, feel free to ignore this if I'm the only one. :-)