Hi,
I recently purchased EasyTOK, and I'm having a bit of trouble. During the mesh-to-rigidbody conversion, the rigid body box/cylinder's (spheres work fine) boundaries are offset from the mesh, so my teapot floats off the ground on one side, and sinks in on the other side (you get the idea?). I followed all the directions exactly as given, any ideas?
Also, is there any support for convex/concave hulls in EasyTOK, using just static bodies, and RB boxes, sphere, and cylinders seems extremely limited.
Any help is appreciated.
I recently purchased EasyTOK, and I'm having a bit of trouble. During the mesh-to-rigidbody conversion, the rigid body box/cylinder's (spheres work fine) boundaries are offset from the mesh, so my teapot floats off the ground on one side, and sinks in on the other side (you get the idea?). I followed all the directions exactly as given, any ideas?
Also, is there any support for convex/concave hulls in EasyTOK, using just static bodies, and RB boxes, sphere, and cylinders seems extremely limited.
Any help is appreciated.