The -1 parameter is the a notation for the serialNumber of the automaticly found instance of the PhidgetBoard when calling
If you install the Phidget software without having any hardware you can run my program and it will wait for an i/o board to attach. So the declerations seem to work. The problem occurs when a i/o board is attached. Therefor I'm dependent of a forum member who has some Phidget hardware to test.
It is very interesting hardware to use for games and interactive shows, though.
PhidgetInterfaceKitCreate(gPhidgetHandle)One can address multiple i/o boards by using this serialNumber, but since I use only one I can use the -1 value.
If you install the Phidget software without having any hardware you can run my program and it will wait for an i/o board to attach. So the declerations seem to work. The problem occurs when a i/o board is attached. Therefor I'm dependent of a forum member who has some Phidget hardware to test.
Unfortunatly I don't think there is anyone where who's used that particular piece of hardware.
It is very interesting hardware to use for games and interactive shows, though.