Well, that "Mesh" might be big enough that your "inside" of it.. and if i'm not mistakin triangles face outwards unless fliped so you won't see anything if you inside of it, try the "FlipMesh mesh" command, if you see stuff then you know your inside of it, now take it off and scale the mesh down with "ScaleEntity mesh,.5,.5,.5" this will scale it down by 50%.
if you still don't see it, scale the crap out of it till you do, if not then i don't see why not unless the mesh your trying to load is a different format then .x
hope this helps
EDIT: did you check to see if your mesh file is in the same folder as the source file?
if you still don't see it, scale the crap out of it till you do, if not then i don't see why not unless the mesh your trying to load is a different format then .x
hope this helps
EDIT: did you check to see if your mesh file is in the same folder as the source file?