Right, so I need a way to pull the subnet mask as you said. So far no searches have turned anything up. Without looking in Windows (cheating) how can you pull the subnet? Is there an easy way to do this in .dll form using some windows programming? I'm sure there is.
Or ... Mark ... yes hello you there! Good sir, might you add a bit more network functionality to Blitz3D in this regard?
Of course ... then would it really be that bad to just do a broadcast for each subnet? How many networks are there with 24 bits or 32 bits of variable ip? Is the worst case scenario most likely a 255.255.0.0?
Or ... Mark ... yes hello you there! Good sir, might you add a bit more network functionality to Blitz3D in this regard?
Of course ... then would it really be that bad to just do a broadcast for each subnet? How many networks are there with 24 bits or 32 bits of variable ip? Is the worst case scenario most likely a 255.255.0.0?