Can i use from an external program that runs in the Terminal (MacOS X) the Textoutput, Status Info etc. in my own Blitzmax GUI like this:
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x1e9702
avrdude: current erase-rewrite cycle count is 1 (if being tracked)
avrdude: reading flash memory:
Reading | ################# | 33% 9.25s
or not?
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x1e9702
avrdude: current erase-rewrite cycle count is 1 (if being tracked)
avrdude: reading flash memory:
Reading | ################# | 33% 9.25s
or not?