@Jfk:
As LineOf7s said, there is an option in Editor Settings->General for Tab value, and if you want to replace TABs with spaces there is also an option "Insert spaces for TABs "
@LineOf7s: LOL, I should replace that B3D194 with a standard one , I have 6 separate versions of B3D installed here, and it was mean to be some kind of "tip" for users to tell them that they can have many B3D versions installed at the same time. You know, if you want to test your code with some older version of B3D without reinstalling it.
I'll look more into this browser problem, thanks for the error report.. just tell me if clicking on the "commands reference" command in the browser works ok ? When the "command reference" page close immediately after starting, does it leave a "blank" tab in the browser, or no tabs at all ?
@Curtastic and Boiled: I think that "unsorted functions" feature will probably come with the next release.
No problem, I'll add this as an option for the next release
Excuse me, probably I missed it, is there a way to set the autoindent char, eg: indent using one tab, or one space, or two spaces
As LineOf7s said, there is an option in Editor Settings->General for Tab value, and if you want to replace TABs with spaces there is also an option "Insert spaces for TABs "
@LineOf7s: LOL, I should replace that B3D194 with a standard one , I have 6 separate versions of B3D installed here, and it was mean to be some kind of "tip" for users to tell them that they can have many B3D versions installed at the same time. You know, if you want to test your code with some older version of B3D without reinstalling it.
I'll look more into this browser problem, thanks for the error report.. just tell me if clicking on the "commands reference" command in the browser works ok ? When the "command reference" page close immediately after starting, does it leave a "blank" tab in the browser, or no tabs at all ?
@Curtastic and Boiled: I think that "unsorted functions" feature will probably come with the next release.
Can it be so that you only have to single click on a function for it to jump to its line of code?
No problem, I'll add this as an option for the next release