> runs fine for the 2.5gHz machine and the 1.8 gHz machine... but when the compiled app is transfered over to a 733mHz machine, there is a lot of jerking, especially seeing as there is a lot of speed calculations and move commands...
this sounds like its not because of the timing
method but because you are processing too much
for a 733mhz machine. particles, mesh deformation,
etc. will do that, won't it?
it may end up delta timing is not much better, you
could have options to switch off a few things eg.
particles for slower rigs.
this sounds like its not because of the timing
method but because you are processing too much
for a 733mhz machine. particles, mesh deformation,
etc. will do that, won't it?
it may end up delta timing is not much better, you
could have options to switch off a few things eg.
particles for slower rigs.