I made this little program today which read a
bitmap and convert it into Data statements source-wise.
But when i tried to include the created sourcefile in
my project I ran into three limitations.
1. The IDE uses A-G-E-S to accept the file
2. The IDE seems to have a limit around 10000 lines of code (1024 kB),
my created sourcefile are snipped off by the IDE before the end of it!
3. Data-statements are only accepted in main code (include file will not do!)
Has anyone overcome these limitations ?
..or should I just drop the idea and use the normal
way and store my bitmap data in a regular file ?
bitmap and convert it into Data statements source-wise.
But when i tried to include the created sourcefile in
my project I ran into three limitations.
1. The IDE uses A-G-E-S to accept the file
2. The IDE seems to have a limit around 10000 lines of code (1024 kB),
my created sourcefile are snipped off by the IDE before the end of it!
3. Data-statements are only accepted in main code (include file will not do!)
Has anyone overcome these limitations ?
..or should I just drop the idea and use the normal
way and store my bitmap data in a regular file ?