The most annoying BLIde bug revealed:
1) Open a BLIde application that holds more than 1 bmx file.
2) Put your cursor into a function (preferabbly inside a TYPE)
3) Go ahead and put some bogus code in the function, say print "bogus code"
4) Now go ahead and tab into another bmx file and pick any like and hit ENTER.
BAM! "End Function" appears out of nowhere and you have to delete it.
I think that's how it works.. you might not even have to put code in another function, but just have to create a new function and then make it and then tab into another file and BAM End function.. either way, sometimes I get End Function to appear out of nowhere. I'll try to track it down further if you can't recreate the problem.
I was hoping this would be fixed in 0.6 but its not just yet! Hope to see it gone in 0.7 or sooner.
1) Open a BLIde application that holds more than 1 bmx file.
2) Put your cursor into a function (preferabbly inside a TYPE)
3) Go ahead and put some bogus code in the function, say print "bogus code"
4) Now go ahead and tab into another bmx file and pick any like and hit ENTER.
BAM! "End Function" appears out of nowhere and you have to delete it.
I think that's how it works.. you might not even have to put code in another function, but just have to create a new function and then make it and then tab into another file and BAM End function.. either way, sometimes I get End Function to appear out of nowhere. I'll try to track it down further if you can't recreate the problem.
I was hoping this would be fixed in 0.6 but its not just yet! Hope to see it gone in 0.7 or sooner.