John,
Make sure you have the port (0,1,2 or 3) set to the one where the controller is connected.
When you go into the control screen can you move the red dots around correctly inside the 2 boxes? - if not, select the correct port number.
You should be able to move the dots to any location in the box using the selected controller port - if not, maybe you need to adjust the scaling factor.
Also - check the Config.txt file and make sure that the line under "[Use Mouse]" says False
Make sure you have the port (0,1,2 or 3) set to the one where the controller is connected.
When you go into the control screen can you move the red dots around correctly inside the 2 boxes? - if not, select the correct port number.
You should be able to move the dots to any location in the box using the selected controller port - if not, maybe you need to adjust the scaling factor.
Also - check the Config.txt file and make sure that the line under "[Use Mouse]" says False