ReadInt(file)
ReadFloat(file)
Look in the 'Command->Streams' section in the help for lots more.
Most commands in Blitz that are going to recieve some data use the brackets around the parameter that is going to recieve that data. Blitzbasic and Blitz3d have done this for years. You'll get used to it and it makes sense after a while.
There was a post about this quite some time ago but I can't find it. Sorry.
Regards
ReadFloat(file)
Look in the 'Command->Streams' section in the help for lots more.
Most commands in Blitz that are going to recieve some data use the brackets around the parameter that is going to recieve that data. Blitzbasic and Blitz3d have done this for years. You'll get used to it and it makes sense after a while.
There was a post about this quite some time ago but I can't find it. Sorry.
Regards