@Tom: Yeap :( Not good, but they are working on it.
@MrC.:
I've setup 2 scripts, one for building - one for running..
The build commandline is:
C:\BlitzMax\bin\bmk.exe makeapp -a $(FullName)
The run is:
$(FileFolder)$(FileName).exe
It could be that before it compiles, it saves the file - if it doesnt associate the file with the correct extension, its not saving in the right format.
I too had problems with it..
Make sure when you defined the language, that its set as PC format - mine was set to MAC.
Save the file, then load it up in notepad - it might give you a clue as to why the file isnt compiling, see if it looks the same as it did in the IDE. For a while - till I figured it out - my files where jumbled up.
Checkout the forums on the sourceedit site, you'll see the problems I had - and what they suggested.
@MrC.:
I've setup 2 scripts, one for building - one for running..
The build commandline is:
C:\BlitzMax\bin\bmk.exe makeapp -a $(FullName)
The run is:
$(FileFolder)$(FileName).exe
It could be that before it compiles, it saves the file - if it doesnt associate the file with the correct extension, its not saving in the right format.
I too had problems with it..
Make sure when you defined the language, that its set as PC format - mine was set to MAC.
Save the file, then load it up in notepad - it might give you a clue as to why the file isnt compiling, see if it looks the same as it did in the IDE. For a while - till I figured it out - my files where jumbled up.
Checkout the forums on the sourceedit site, you'll see the problems I had - and what they suggested.