Just to clarify what I am getting at - and I accept this could be complete rubbish:
Take the Blitz3D built-in example for 'AddTriangle' or 'AddSurface':
Technically, Blitz will let you add as many as you like 'AddVertex' commands under the first three - so you could have v3 = AddVertex (surf,xxxxx) all the way up to v1000 = AddVertex (surf,xxxxx)
Can you only process 3 at a time - is there a work-around to apply (for example) 20 'AddVertex' commands at once to a 'Surface'?
Edit:
On paper, you can make a square out of 4 of them.
Take the Blitz3D built-in example for 'AddTriangle' or 'AddSurface':
v0 = AddVertex (surf, -5,-5,0, 0 ,0) v1 = AddVertex (surf, 5,-5,0, 1 ,0) v2 = AddVertex (surf, 0, 5,0, 0.5,1) tri = AddTriangle (surf,v0,v2,v1)
Technically, Blitz will let you add as many as you like 'AddVertex' commands under the first three - so you could have v3 = AddVertex (surf,xxxxx) all the way up to v1000 = AddVertex (surf,xxxxx)
Can you only process 3 at a time - is there a work-around to apply (for example) 20 'AddVertex' commands at once to a 'Surface'?
Edit:
On paper, you can make a square out of 4 of them.