Ummm, dumb question but how does one refer to one's static mesh after it has been set? I'm trying to convert some ODE stuff over to compare but whereas, in ODE, you go...
...which gives you the handle "TriMesh", in Tokamak it's just...
...which leaves you with nothing. So, what's the right way to interrogate and set the position and orientation of the static mesh in Tokamak? Looked high and low I have.
TriMesh = ODE_dTriMeshCreate(mesh)
...which gives you the handle "TriMesh", in Tokamak it's just...
TOK_AddMesh mesh TOK_SetMesh
...which leaves you with nothing. So, what's the right way to interrogate and set the position and orientation of the static mesh in Tokamak? Looked high and low I have.