Hi everyone. I sorted out the problem. My corridor was too long, and the light was right at the middle. I did a test where the light was following the camera. It lights up when you get close to the edge but darkens near the middle. I'm guessing its because the light is worked out at the corners. Thanks for all your help though. I've certainly learned a lesson! From now on... lots of smaller surfaces.
Surfaces Not Illuminated
Blitz3D Forums/Blitz3D Programming/Surfaces Not IlluminatedThe forum is locked. These are the original blitzbasic.com forums, kept so they can still be read. No new topics, replies or edits can be made here. To join in, head over to the Blitz3D+ forums.