Hi Soja,
I thought I'd tried retreiving the address of the banks from a CALLDLL from Blitz only to find that writing to the actual address from PB then caused Blitz to crash (Page Protection fault - if I remember) - but seeing as you have successfully done this I'll try again.
PS. I'm not trying to return a value from a call to a DLL procedure to a Blitz bank. What I am trying to do is identify where the bank actually is in memeory and then have another exe/dll (from PB) perform calculations from serial data and write its results directly to that Blitz Banks RAM address - so that in Blitz I only have to read from a bank to get the latest result from the exe running seperately in parallel.
I thought I'd tried retreiving the address of the banks from a CALLDLL from Blitz only to find that writing to the actual address from PB then caused Blitz to crash (Page Protection fault - if I remember) - but seeing as you have successfully done this I'll try again.
PS. I'm not trying to return a value from a call to a DLL procedure to a Blitz bank. What I am trying to do is identify where the bank actually is in memeory and then have another exe/dll (from PB) perform calculations from serial data and write its results directly to that Blitz Banks RAM address - so that in Blitz I only have to read from a bank to get the latest result from the exe running seperately in parallel.