You would be able to setup a default "blueprint" property that gets added to every layer created.
So any time you created a layer, it would add:
"X speed" FLOAT default = 1.0
"Y speed" FLOAT default = 1.0
to the layer.
Then you can simply modify these values depending on your engine. That was my main idea. Not to tie it to a particular set of properties or conventions, and make it totaly open :)
So any time you created a layer, it would add:
"X speed" FLOAT default = 1.0
"Y speed" FLOAT default = 1.0
to the layer.
Then you can simply modify these values depending on your engine. That was my main idea. Not to tie it to a particular set of properties or conventions, and make it totaly open :)