Nah, did some further testing. Other code works fine, just this one thing doesn't.
I run it in the ide, it works. I create an .exe, place same dir as the source. It crashes.
BUT, I placed a wait key right after the graphics call to check if it was a error with the .exe. Nope. Run and waited until I pressed key then mav...
So it appears it's refusing to load something or create something when ran as an .exe, yet works fine when ran from the ide.
This is the wierdest bug I've ever seen...
I run it in the ide, it works. I create an .exe, place same dir as the source. It crashes.
BUT, I placed a wait key right after the graphics call to check if it was a error with the .exe. Nope. Run and waited until I pressed key then mav...
So it appears it's refusing to load something or create something when ran as an .exe, yet works fine when ran from the ide.
This is the wierdest bug I've ever seen...