Usually I do 1 unit = 1 meter in MAX.
In Autocad 1 Unit = 1 Millimeter, because that's how the architects draw here. (DK)
Terrain is usually in meters too.
Your generic dude would be about 1.8 units high, if he is in meters.
When run as a walkthrough model in Blitz, I often scale everything to fit the view setup anyway.
Make sure that everyone you work with sets up MAX units correctly from the start. Even though there are workarounds, it's a real pain exchanging models when some are in inches, some in meters and some in "erhh - I don't know, how do I set that up?" :)
In Autocad 1 Unit = 1 Millimeter, because that's how the architects draw here. (DK)
Terrain is usually in meters too.
Your generic dude would be about 1.8 units high, if he is in meters.
When run as a walkthrough model in Blitz, I often scale everything to fit the view setup anyway.
Make sure that everyone you work with sets up MAX units correctly from the start. Even though there are workarounds, it's a real pain exchanging models when some are in inches, some in meters and some in "erhh - I don't know, how do I set that up?" :)