Lee,
The .b3d file that wouldn't load into Blitz happily loads into DECORATOR. If I then save it back out as the same .b3d file it loads ok into Blitz. So from this you could assume that both DX8 to B3D and GILE(S)are exporting the file differently to DECORATOR. However as a test I loaded the DECORATOR file into GILE(S) saved it again as .b3d and Blitz loaded it ok. Any ideas on what's happening?
So the procedure now is, export the model from 3DCANVAS in .x, load into DECORATOR and do whatever,save as .b3d, load into GILE(S) and do the lightmap,export as .b3d and load into Blitz.
>Carpman
The .b3d file that wouldn't load into Blitz happily loads into DECORATOR. If I then save it back out as the same .b3d file it loads ok into Blitz. So from this you could assume that both DX8 to B3D and GILE(S)are exporting the file differently to DECORATOR. However as a test I loaded the DECORATOR file into GILE(S) saved it again as .b3d and Blitz loaded it ok. Any ideas on what's happening?
So the procedure now is, export the model from 3DCANVAS in .x, load into DECORATOR and do whatever,save as .b3d, load into GILE(S) and do the lightmap,export as .b3d and load into Blitz.
>Carpman