True :) btw I need one of those 3D Printers ;)
BTW PANNO I made some new Tests with the 3D Scanner Project, using your DLL, but I came to the conclusion that I need at least 640*480 Pixels to get a Scan that is useful in any way. At the moment the Laser Line Width differs from 0 to 6 Pixels, depending on the angle the beam hits the Figure. Of course, this is way too much for a 10 cm high Sculpture with 0.25mm Details on the surface. I think I will have to use 30 cm Sculptures painted completely white and scanned in at least 640*480px.
If you could implement a resolution selection in your DLL? I know, I already asked for the fast Hack Version... But unlike some Motion-capturing experiments, the 3D Scanner doesn't have to be very fast, instead a higher resolution would be useful. However, if I am gonna sell anything of these things I'll send you some cash for the DLL - promised!
BTW PANNO I made some new Tests with the 3D Scanner Project, using your DLL, but I came to the conclusion that I need at least 640*480 Pixels to get a Scan that is useful in any way. At the moment the Laser Line Width differs from 0 to 6 Pixels, depending on the angle the beam hits the Figure. Of course, this is way too much for a 10 cm high Sculpture with 0.25mm Details on the surface. I think I will have to use 30 cm Sculptures painted completely white and scanned in at least 640*480px.
If you could implement a resolution selection in your DLL? I know, I already asked for the fast Hack Version... But unlike some Motion-capturing experiments, the 3D Scanner doesn't have to be very fast, instead a higher resolution would be useful. However, if I am gonna sell anything of these things I'll send you some cash for the DLL - promised!