These are all great suggestions but I have already tried most of them before. I don't know if I really knew what I was doing but I did use the create pivot command something like this:
pivot=createpivot()
loadmesh("Sword.x", pivot)
... ;do some other code
turnentity pivot, 0, 1, 0
I am using 3D canvas Pro. I have found the place where it says that the pivot is and it is somewhere in the middle of the blade of the sword. (I unioned all the pieces of the sword starting from the bottom and working my way up.) This may however, be the wrong pivot so if anyone has been using 3D canvas Pro, please tell me exactly how to do this since I am beginning both 3D canvas and BB. Thanks for any help you can give me on the subject.
pivot=createpivot()
loadmesh("Sword.x", pivot)
... ;do some other code
turnentity pivot, 0, 1, 0
I am using 3D canvas Pro. I have found the place where it says that the pivot is and it is somewhere in the middle of the blade of the sword. (I unioned all the pieces of the sword starting from the bottom and working my way up.) This may however, be the wrong pivot so if anyone has been using 3D canvas Pro, please tell me exactly how to do this since I am beginning both 3D canvas and BB. Thanks for any help you can give me on the subject.